LEDGLOW Rev Strobe How ?
302
Published 2017-09-28
Green Wire(not use)Low Power Option=used to decrease brightness of strobes. This is useful for demo cars at shows or in showrooms where it might not be possible to strobe at full brightness.
Blue Wire connects to Reverse bulb wire(pick one out of 2 only need to tie into reverse bulb wire on 1 side of vehicle) This allows lights to operate when car is put in reverse.
One will need to drill a whole and put grommets in passenger side and driver side tail light compartment to run strobe bulb wires through wall or can run strobe bulb wires as one see's fit.
One will need to pull entire tail light assembly out to dump debris from assembly.
No need to install 2 strobe lights in reverse bulb chamber , one in each reverse bulb chamber will suffice. Other 2 can be back ups for when installed ones blow.
1 inch/1" over from center of clip hole
2 inches/2'' up from edge face of tail light assembly.
I wasn't saying I will install them for you lol.
All Comments (4)
-
Hey man I really like this kit. Might need your help on install. I’ll keep the video on repeat. Hey man you in houston by chance?
-
I wish you lived near me so I could get some lighting install help bro.
-
do you have an "after" video at night
