How to change a car battery without loosing memory in MODERN CARS!!!
199,912
Published 2018-12-04
Here are a few reminders when replacing or changing a car battery especially for modern cars
Negative cable first for removal
Positive first for installation
Always keep horizontal
Make sure to use a Memory saver
QUICK LINK TO BUY THE Memory Saver FROM AMAZON WITH QUICK SHIPPING: amzn.to/33PCpuB
***********
FOLLOW US ON INSTAGRAM! - www.instagram.com/thejabbour/
***********
All Comments (21)
-
Hands down. One of the best videos out there that shows clear steps and showing safety steps properly
-
Wish i found this video soon. Too late . My engine was violently shaking after swapping out my battery. Lost all presets and memory of how my car was supposed to run. Well now I know.
-
Thank you so much, you made it clear and easy to understand
-
I'm about to change my battery, it's very important that I have to watch this carefully
-
When using a memory saver the positive cable stays hot, put a rubber glove over it so it doesn't ground out.
-
I used the same method but I only needed a 9v dry battery to maintain the memory whilst I swopped the car battery. I made sure that all lights including the courtesy (door open) light was off and that the infotainment system was off. It worked fine.
-
I don’t have a small power source , can I connect the positive and negative cables to another cars battery ??
-
102.3 you must be in Florida thank you for this video
-
Very nice explanation. Thank You!
-
It was a good video on how to save your presets my question would be why would someone put a new battery in and not clean the cables?
-
there's an additional step that might be necessary. The battery monitoring system will need to be reset, coding the new battery to the car, allowing the charging strategy to be adjusted for the new battery. You'll need a suitable diagnostics scan tool for this, or might need to pop into a garage or dealer that has this equipment. The car will likely run just fine on the new battery, but an incorrect charging strategy could reduce the lifetime of the battery.
-
So if you plugged the booster pack into an always on cigarette lighter port would it work the same way?
-
Is the cable long enough to reach a nearby car?
-
I’m trying to reset my PCM If I leave my battery off for few days Then fit again will the PCM reset then I’ll do the running ecu relearn it’s an rx8 with p0610 code
-
Just use an extra fully-charged battery on the side to power using a jumper cable.
-
I've replaced batteries in a 05 lexus, 15 sienna, and a 16 Altima. Never used the memory saver and they still had all their memory.
-
Should you have wiped a little grease on the battery terminals after installing?
-
Thank you!!! LIKE LIKE LIKE :-)
-
Hi, Ryan, what State do you live in? Looks nice!
-
Showing a 12 V accessory to plug in your computer saver, is OK if you have one. It would have been better if you would have also shown how to connect if you don't have the peripheral equipment.
