Ender 3 Pro ( modded ;) ) #SpeedBoatRace 12:35

The2mD
The2mD
804
2
Published 2021-11-02
after forgetting to make a video of my speedbenchy yesterday, here's a video of one printed today. but although its the same Gcode, i got a bit more lifting on the bow then yesterday... ( maybe different ambient temp/moisture ? ) but it still completed even if it scraped the fanduct ( its very low so it scrapes on everything that's sticking up )

Used standard Speed benchy settings:

- PLA Tinmorry Black Matt ( 210C° nozzle / 45°C bed )

- 0.5mm nozzle ( and line width )

- 0.25 layer Hight

- 3 top and bottom layers

- 2 walls

- 10% infill ( line )

- 170mm/sec speeds on everything ( flowrate of 21.25mm³ on a stock heater block/cartridge )

- 13000 mm/sec² acceleration
All Comments (6)
  • @CraigParkerD
    I think I am as impressed with quality with speed, great combo here!
  • @Jakob3xD
    This was impressive! Would you recommend upgrading to linear rails? What was the Initial reason to do it? Did you use build volume? What kit? (if you used one)
  • @ManagedUx
    Nice, I'd be interested to know just what mods you're Ender 3 Pro is running if you're willing to share.