DO YOU EVEN LIFT BRO? | Giving the Pajero a 2 inch Lift
17,812
Published 2022-11-21
#mitsubishi #pajero #mitsubishipajero #montero #4wd #4x4 #pajeromods #ozpajerolife #pajero4x4
All Comments (13)
-
By coincidence I just indexed my 93 Pajero today. The front was 4+cm low. After removing the bolt and dropping the torsion arm the end that the bolt is in slide off. I just rotated the bracket that the bolt goes thru 2 teeth. I tightened it up and adjusted it so the wheel well arch was the same front and rear. I drove the vehicle forward and back and readjusted the height a few times until it stayed where I wanted it. Odd part is after indexing the drivers side, the passenger side front is now even with the passenger side rear. Looks much better. Informative video. Keep up the good work.
-
Have you thought about the 25mm upper ball joint spaces? To prevent the chopping of the bump stops? Grate video love your rig & vids! 🤙🏽
-
Thank you much bro!
-
Gen 2 🙌🙌❤️
-
2inch is a safe lifted.for a good 4H proformmance,do not lift over 9cm or the cv joint would break imedately
-
Awesome
-
Good video bud, I wondered if I should do that to my car..
-
Hi sir, im planning to reindex my torsion bar as well. May i ask, how many splines/teeths did you reindexed on the bar tp get the 2 inches? Thank you.
-
what suspension do you have in front?
-
bro how about at the back side.?
-
This one lift up body without added accesories bro?
-
Are you Perth scooter?