Add a Fuse Tap in Your Vehicle To Power Your Switch Panel!

AZ Overland
AZ Overland
18,162
0
Published 2023-09-06
I've been asked the question of which fuse I used to tap in to to power my Switch Panel so many times, I decided a video on this is due.
Please refer to my Pinned comment below for more info.

*Test Light (upgraded):
amzn.to/44LW5LA

*Butyl Sealant:
amzn.to/44IMdT1

AUXBEAM Switch Panel - How To Wire Video:
   • AUXBEAM 8 Switch Panel - How To Wire  

*Auxbeam 8 Gang Switch Panel Kit
amzn.to/3FcJJ5I

*Power Fuse Block Shelf Bracket (silver)
amzn.to/3i4ij9k

*this channel may receive a small commission when ordering from certain links. Thank you for your support
All Comments (21)
  • @AZOverland2017
    *Important Note* I did not go into details on putting that fuse tap in the correct way in the slot where the factory fuse comes out. Make sure if looking at the slotted openings in the fuse tap, that the left prong that goes into the factory spot, is inserted to the power (source) side. You can easily check this by turning the key to ACC or ON and testing each side with the test light. The one that lights is the power (source side).
  • @vin6930
    Found it! Thanks from Australia. Vinnie.
  • @pierrececile9611
    Middle finger part was funny. Excellent video, well explained thanks a lot
  • @Grimdegn
    Excellent! Well explained for a novice like me.
  • @hamanyarmani8474
    Very helpful 👌big thanks from Bahrain (around 10k miles away)
  • @acet7
    The video was helpful, thank you.
  • @geoffpennington7488
    I got more info from this than the guys from Ford. I’m trying to add some pod lights to a 2019 Ford Edge St. I’ll do the test light thing tomorrow, I have fuse taps and a relay. I’d like to get the pods to come on with the DLR’s. No luck tapping into headlight connector wire that goes to DLR. So going to try this, maybe I’ll get lucky. Thanks for the great video!!
  • @aphamnet
    Thanks for some great content. Something not mentioned is orientation does matter when inserting into your fuse box using an add a fuse. The power side on the fuse box needs the add a fuse prong side that has continuity to both fuses even when one fails. There are many videos on correct orientation when using an add a fuse that should explain