majdq8 handle mod Part 2 Handle Shaping

majdq8
majdq8
30,588
0
Published 2016-12-06
This is Part 2 of 3 of my Handle Mod video. I go through how I build up my handles. I do think many of you can do a much better job than me, but this is how I do it and it works really well. Please look at the Theory part first to get a better grip of what the ideas are.
All Comments (18)
  • @Loresan_
    Thanks for this clip, i decided to make a right handle for my arbalete...it is a ergal cressi with 110 band stretch and 1100gr only gun ( no shaft no bands) Do you think is too much with 7.5mm shaft and double 15mm bands? Thanks ciao
  • @Lorbek007
    Hi majdq8, Your work is truly impressive! Could you help me with something? I have Pathos Laser Open Pro 90 with 6.5mm shaft (original) and I recently ordered new bands Sigalsub Band 14.5 mm Coestruso Sigal Extreme. Could you please help me on what length I should cut them? I have in plan modding the handle by your video and upgrading the trigger with the Ermessub upgrade kit. Thank you very much ;)
  • @guamanfish
    Hello majdq8, I know it’s been a while since this vid was up but I came back to review it again. And ever since I watched it for the first time, I still can’t seem to wrap my head around your memory locking procedure (your use of line level to be exact). I understand your concept, but what’s the exact purpose of the line level here? Can you explain in detail if possible? TIA (your content is gold btw!)
  • @primalphysique
    im about to do this mod but without the carbon fiber part :) but i’m curious when the epoxy putty does get damaged, how do i fix that? if i want to redo the whole epoxy handle, how can i reset (or take it off)? using a dremel or metal file?
  • @amjedalattas
    really amazing series of videos came in time really Thanks a lot just could you point me where did you get the material especially the carbon fiber wrap??
  • @JMurphy0213
    What Grit of Silicon Carbide powder do you recommend for the friction layer? I don't want something that will rip my gloves up fast, just enough to give a bit of friction to the handle. Thank you!
  • @peyopires2676
    Hey , i m in France , and i saint to do this, but no found Carborundum. Have you a solution Please? Good day
  • @terrymoreto3989
    hello majdq8 ! to the end, can you say me who's grit do you used for the grip handle ? it is a carbure sicilium ? thank you so mutch !!
  • @georgekorros5659
    the trigger on the abellan is plastic?If so being plastic doesnt affect the durability of the gun ?Also for the pin holding the line on the mech is it possible to be swapped and from right side to be placed left ?
  • @Ivesy85
    Hi majd looking to do this to my pathos. Is there any issues with stopping just at the expoxy potty part. I'm not concerned about looks and I don't have the skills to do the carbon fibre part. Was hoping it's ok just to leave the putty as is or will it fall apart with use ??
  • @juanpedrohernandezperez8608
    Hi majdq8, First of all, very nice video. I have a question. What trigger is the one that appears at minute 58:48 put on the speargun pathos? Bests regards.