Tips

Already had someone add a good tip. If you purchase a table with Torch Height Control (THC) you will receive a box that includes a module that will need to be inserted on the control board inside the electronics box. In Chapter 14 of the assembly manual you are instructed to install the electronics enclosure and at the end to screw the cover in place. You aren't told to install the THC module until much later in the "What's Next" section which means you have to remove all the electronics cover screws (including the ones on the bottom that you practically have to lay on the floor to access). SO if you order THC install the module in Chapter 14 while you have the electronics enclosure open.

Thank you for the tips and detailed explanation of the bearing block assembly and alignment!

Lots of great tips. Thanks for posting. I'll have to remember these when my table arrives.

Very helpful. Thanks!

Squaring up the frame with the loose legs on was one of the hardest parts of the assembly, glad you covered it. I had a huge welding table to square it up on, but it still gave me trouble.

Thank you for taking the time to make the videos

After assembling my first crossfire pro, I've had the experience of assembling one table three-four times.

Appreciate the videos

Awesome video I’m waiting on last box so I now have a good game plan thanks to you 👍

How do you manually tram the z axis torch slide so it perpendicular to the bed? I cannot seem to get the video to work in the instructions

By chance can you tell me the dimensions of the bottom shelf you made for it?

You didnt install any of the tube inserts to not smash the tube?