Mounting a Vortex Venom red dot sight, on a Glock 22, Gen 5 MOS.
6,444
Published 2021-07-03
this video is a partial re-shoot, because the first attempt at recording my phone had died 3 minutes in. I reset everything I had done so far, and began again.
enjoy!
All Comments (7)
-
Just bought the venom 3 moa for my Glock 43X mos and the darn thing doesn’t fit. 😒
-
How did the red dot hold up for you? Did you eventually torque it down to spec? I have not tried the Venom but I’ve put my toes into the water of red dots and really like them, actually prefer the over iron sights. It takes some getting used to especially finding the dot in the window on presentation but after some practice it becomes much easier. Good luck and hope you enjoy it.
-
Where did you purchase the mounting plates at?
-
Just bought a gen 5 23. Trying to decide between the vortex venom and holosun 407c. How is the vortex working out for you so far?
-
I have the same question as others. How has it held up? Hold zero ok? Stay on the slide without issue?
-
The MOS screws come with the venom right?
