HBI FN PS90 Optic Mount Install
11,611
Published 2023-04-06
All Comments (14)
-
Oh boy just what i needed just bought a PS90 and have the same optic
-
Amazing product 👍 very happy with it 🤩
-
Great video, made installation simple ⭐⭐⭐⭐⭐
-
Thanks for putting this out.
-
just what I needed to finish my build. Thanks!
-
Solid mounts!
-
Brilliant solution. I'm getting one. THANKS I have a PS90 with ManCave (I think) low Pic rail to low mount my Vortex SPARC II red dot. Works fine BUT I would like to move my HOLOSUN 509T circle/dot sight from my RUGER 57 pistol to my PS90. Your mount is the answer! BTW, I have the AEMS on the barrel short Pic rail on my 9 mm RUGER PC chassis carbine. BEST PCC red dot, IMHO.
-
Should you loctite the rear screw that holds the mount down?
-
I'm trying to decide between the RMR & AEMS mount right now. Is it significantly lower than factory?
-
Any suggestions for an optic to get the lowest profile lowest HOB without going to a new receiver on these? I have a vortex venom mounted on the factory 1913 rail I think it's about 4 inches height over bore measured with my calipers from the center line of the red dot to the bore. I think I should be able to drop heigh around an inch without that super thick rail adapter in the way lol. Guessing those micro red dots get a little lower than something like a t2 or an aems or 510c or something.
-
Can you make a video with the Trijicon MRO ? I’d like to see how it would look with your mount.
-
Next time don't talk sooooo much, I couldn't watch the entire video 😢
-
That's a P90 not a PS90. The short barrel length is the giveaway. PS90s are longer.
