Flamco Flexcontrol: simple checking of expansion vessel pre charge
95,140
Published 2017-05-01
All Comments (9)
-
So turn right to isolate and drain, turn left to close drainage and connrct to the system again? I remember using one of these valves but there was no manual available at the time...
-
Very informative.
-
😂prawie się udało ,ale porusza poważny problem 👏
-
is that balloon analogy the case will vessels then? they will always inevitably lose pressure? thanks
-
is there a scheme for the operation of this device, which directions opens and which closes in opposite positions ?
-
what literally everyone sees: flamco what I see: flamingo
-
It would be useful to know the pre-charge pressure required for a given system pressure
-
But from the looks of it, since the Expansion vessel is high up, you aren`t completely empyting it out of the water to have an accurate meassurement. It might say 0.65 but in reality it could be alot less.