Homemade CHAINSAW BIKE
354,598
Published 2021-04-18
Unfortunately because of my mistake, the motor cant work on low wheel revolution.
Its like that because the scale between the sprockets on the chainsaw and the wheel is 1:2 .
To make the bike work better at lower wheel revolutions it is recomended to have bigger scale of sprockets between the chainsaw and the wheel.
I have in plan to make a more simple and yet better version of this bike, so subscribe and enjoy the new videos.
Email : [email protected]
I hope you've enjoyed watching this video.
╔═╦╗╔╦╗╔═╦═╦╦╦╦╗╔═╗
║╚╣║║║╚╣╚╣╔╣╔╣║╚╣═╣
╠╗║╚╝║║╠╗║╚╣║║║║║═╣
╚═╩══╩═╩═╩═╩╝╚╩═╩═╝
All Comments (21)
-
Hey I have a problem so I welded the sprocket on the outside of the clutch and I’m using the stick 7 speed on my rear wheel so when I hooked it all up I couldn’t pull start it unless I lifted the back wheel up because it was to hard because of the chain so I had to lift the back wheel up but when I did that the chain fell off cause it was loose, do you think that’s cause I need a chain tensioner?
-
You made your own sprockets... you are the man 😁
-
In all the videos at the end the saw doesn’t sound under any load. Just seems like you pedaled really fast and coasted by in the video frame because each pass was so limited in distance covered. Just saying that saw doesn’t sound like it’s under any load at all.
-
👍👍интересные
-
All that weight should have been lower inside the frame and just use the pedal gear thats on the inside of the pedal set of gears
-
You could have use a bicycle gear and weld in on the backside of the chainsaw clutch
-
Put the tensioner to the slack side
-
Que legal ótima idéia brother. 👏👏👏
-
Amazing editing and skills wow
-
Very inventive! Good job
-
Монтаж на высоком уровне!
-
Parabéns muitos bom mesmo Deus abençoe sempre sua vida amén 👍👇👍 Deus abençoe todos meus escritos amén 🤔😳👏👏👏👏👍👍
-
I would have had to clean and shape my brackets! I know it works and is well designed but I would have to grind down and shape the metal and paint it.
-
Nice build. Your gear ratio is wat off, even worse than my first friction drive builds but I realy like your ideas ! The video montage is very nice too !
-
Awesome ❤
-
Is the clutch getting hotter?
-
👏👏👏👏
-
❤❤❤❤ perfect
-
👍👍👍👍👍👍👏👏👏
-
Is that the best ratio you have figured out with using the chainsaw? I'm about to try putting a chainsaw on a trike I have so I'll have the motor on the front tire so there is less wear on the motor any suggestions would be appreciated
