How to install a Brushless motor without a Hall sensor on a standard Brushless motor controller

@SonnetGomes 10 months ago

Thank you so much for this helpful video. I was able to salvage an old motor with damaged hall sensors. It is much easier to maintain the motor without hall sensors.

@ThriftStoreHacker 3 months ago

thanks for this information! I have 3 36v hub motors that were given to me and most of the hall wires are completely destroyed. This is exactly the video I needed to get them up and running without the hall wires. Thanks again.

@mikebroom1866 1 year ago

I've been planning on using mine to make an e-bike. Need a sprag clutch first.

@jesselunt3269 1 year ago

Hello there my friend thank you for another perfect lesson on the learning wires. I have a few questions about solar power in the home. Where can we discuss this?

@pietvisser336 5 months ago

Could you please post a scheme how you have connected the other wires from the controller and to which wire you have connected your speed pedal. I am stuggling to connect brushless motor without Hall but it wil only turn 2 or three stepd of 30 degrees and then it stops. Thanks in Advance, Piet Visser

@hamzaMaster 3 months ago

Hey brother, thank you so much for sharing this video. Please tell me how you can my motor. You have three cables It has no sensors, but the control event has sensors, will it work with it?

@escapegoat3472 9 months ago

Do you have a video on your mid drive ebike you show at the end of the video? Thanks.

@EBIKESBR 11 months ago

How to adapter sensor hall on motor ?

@ElTelBaby 1 year ago

? What is the Ohm of the peddle switch used & Wattage...

@yusifsuleiman5502 1 year ago

Thank you for your kindness. I want to replace a pedal assistant sensor (PAS) with a throttle on my ebike and I use the throttle 3wires in the position of the PAS, and it doesn't work. I will appreciate any assistance. Thanks

@JakDac 11 months ago

Can this motor be used for ebike ?

@robertriggs2616 3 months ago

I have a 48 volt 750 watt blcd motor. the problem im having is too much power at take off. it doesn't seem to have a variable power output. why is this happening ?

@mhmdsaleh3502 7 months ago

Please sir . I have a motor connected without hall sensors , it works with very loud noise and with 10a without load !!! Is this because I SHOULD connect the sensors or it may work and I must replace the controller ???? Please give my help ig you could

@deankdx 1 year ago

that's perfect! i will have to check what controllers i have now. what is that throttle pedal you have? is it same as an electronic sewing machine one?

@philiptuffs-wh7jp 21 days ago

Hi I am building a e-bike with a bosch e bike motor this has no hall sensors , the motor is being connected directly to a bafang speed controller . I have made a pedal assist setup on it, but the motor will not run , any ideas can I do a mode to the speed controller hall sensor wires . Or is it a case the speed controller will not work like this . Any controller you would advise make model thanks