Only Experiment || How Replace Broken Melted Axle Teeth with scrap Pinion Teeth By minded Mechanic

Good job! Even the shaft is a bit crooked, all tolerances are less than 2 fingers.

Заготовки можно не отпускать при помощи газовй горелки....они от тупых резцов сами отпускаются.

Человеческий ресурс в этой стране ни стоит ничего.

You don't need threads to fix it, you just make a press fit and it will be better!

Мой станок пурпурного цвета я на нём точу зимой и летом ! Полуоси и коленвалы всё что угодно из металла

Please update these "repairs" with info on how long they lasted. THX!

Very good work. I like how you repair things, and not just throw them away. In Norway this axle would been scrapped, and the owner would need to buy a new (and very expencive) axle. Greetings from Norway.

shouldnt weld loke that using the lathe as a ground wat happens is that the current goes through the bearings of the lathe partly welding the balls to the races and wearing them out verry rapidly if you do need to weld on a lathe make sure the groundstrap is on the piece youre welding not on the lathe itself seen a few of this exact repair where they wittle down the shaft to half its size fit a new piece with a hole over it and weld it up , they done it a few time so it aparently works , i just wonder for how long as theres a pretty big twisting force on a halfshaft

приваренный шлицевой вал бьёт относительно оси. а что там по твёрдости?

folks, we got a concrete floor. expert mode engaged.

I really like your videos, your work is very good. Good effort and excellent skills.

интересно,а эти ребята вообще в курсе существования болгарки,фасонных резцов,отрезного резца,особенностей термообработки полуосей? не,работать оно как то будет,но сильно меньше нормальной полуоси ..

The job looked great when finished, but could never be as strong as a new replacement. Also, I feel that (if you are going to weld the job whilst it's still in the Lathe), it would be better to place the Earth Electrode directly onto the shaft being turned. In this way, the extremely high Welding Current will not be transmitted through the Lathes valuable Headstock Bearings - where there is some resistance due to oil, and the Ballraces themselves.

! Magnifico trabajo ! Felicitaciones desde México.

Serviço super profissional! Excelente!

у этого пакистанца даже станок новый,ОГО

Great fix. Didnt see him measure OD or number of splines but they might have been pto shafts with interchangeable parts.

Interesting fix. But, that's all soft metal. He doesn't seem to have a way to heat treat anything for strength. But, good enough for a roadside repair, I guess?

minded Mechanic👈👈👈👈👍👍

Это потрясающие умельцы,просто превосходная работа